Minix Man Pages
home | helpx minix x x minixx LVM2-ACTIVATION-GENERATOR(8) LVM2-ACTIVATION-GENERATOR(8) NAME lvm2-activation-generator - generator for systemd units to activate LVM volumes on boot SYNOPSIS /lib/systemd/system-generators/lvm2-activation-generator DESCRIPTION The lvm2-activation-generator is called by systemd(1) on boot to gener- ate systemd units at runtime to activate LVM Logical Volumes (LVs) when global/event_activation=0 is set in lvm.conf(5). These units use vgchange -ay to activate LVs. If event_activation=1, the lvm2-activation-generator exits immediately without generating any systemd units, and LVM fully relies on event- based activation to activate LVs. In this case, event-generated pvscan --cache -aay commands activate LVs. These systemd units are generated by lvm2-activation-generator: lvm2-activation-early.service is run before systemd's special crypt- setup.target to activate LVs that are not layered on top of encrypted devices. lvm2-activation.service is run after systemd's special cryptsetup.tar- get to activate LVs that are layered on top of encrypted devices. lvm2-activation-net.service is run after systemd's special remote- fs-pre.target to activate LVs that are layered on attached remote de- vices. Note that all the underlying LVM devices (Physical Volumes) need to be present when the service is run. If the there are any devices that ap- pear to the system later, LVs using these devices need to be activated directly by lvchange(8) or vgchange(8). The lvm2-activation-generator implements the Generators Specification as referenced in systemd(1). SEE ALSO lvm.conf(5) vgchange(8) lvchange(8) pvscan(8) udev(7) systemd(1) sys- temd.target(5) systemd.special(7) Red Hat, Inc LVM TOOLS 2.03.07(2) (2019-LVM2-ACTIVATION-GENERATOR(8)
NAME | SYNOPSIS | DESCRIPTION | SEE ALSO